There is literally no difference in how buttons are sent via minimal or firetv. Jason: Can you confirm a difference in the code between the Minimalist setup and the Fire TV? I'm guessing the Fire TV is sending a more continuous burst, whereas the Minimalist only sends one or two bursts? I hope this will help someone having similar difficulties. She can now navigate the Fire TV without any issues. I then changed the Inter-Key Delay from the default 3 to 2. On a whim, I replaced the Fire TV remote programming with the Minimalist programming and noticed an improvement. I was able to duplicate what she was experiencing almost literally by just thinking about holding the buttons rather than just clicking them. had been having intermittent difficulty with the 5-way on our universal remote due to a motor skills problem. Is this familiar to anybody? Edited Februby fgarcor I let it be and then.yes, it works again normally. It doesn't do anything in the next 15-45 seconds. I switch on the unit, and I press right arrow. However 0 or 6 didn't make any difference.Īnd I have observed, after switching on the fireTV that sometimes it takes around 30seconds for flirc to start taking the signals properly. My problem is that I press the button for long and it does send only 1 press. But my understanding from this post is that if I want to get multiple key presses I have to reduce it to 0. Unfortunately it doesn't trigger a CEC command to send a shutdown command to all the connected devices, but it is enough like this. I map the "power" button from the multimedia profile in flirc to one of the remote keys.In my case, the power button. The standy I do it just following your instructions on one of these forums (I cannot remember which one, I read several). I am sure that you have seen one of those keyboards at some point. multimedia keys: play, ffwd, rewd, stop ZoomIn/Out are two special keys that can be found in some keyboards with extra keys like: Thanks I will try that one with the interkey. How are you doing your standby? Did you map a specific key? I'm not sure what you mean zoomin/zoomout? You referring to Kodi? You should change your interkey_delay settings in the gui to 5 or 6, that should help the repeat
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |